Range Rover Evoque: Evaporator LHD
Removal
NOTES: The removal of this component involves cutting an aperture in the evaporator housing wall and cutting through the high and low pressure A/C lines. A service repair kit is supplied to cover this procedure.
Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - GTDi 2.0L Petrol (412-00 Climate Control System - General Information, General Procedures).
Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - TD4 2.2L Diesel (412-00 Climate Control System - General Information, General Procedures).
3. Refer to: Plenum Chamber (412-01 Climate Control, Removal and Installation).
4. Refer to: Central Junction Box (CJB) (418-00 Module Communications Network, Removal and Installation).
5. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
6.
7. Torque: 10 Nm
8. CAUTIONS: Make sure that all openings are sealed. Use new blanking caps.
Lubricate the new seals with clean refrigerant oil.
NOTE: Install new O-ring seals.
Torque: 9 Nm
9. Torque: 4 Nm
10. NOTE: LH illustration shown, RH is similar.
11.
12.
13.
14.
15.
16. Torque: 10 Nm
17.
18.
19.
20.
21.
22.
23.
24.
25. CAUTION: Make sure that the area around the component is clean and free of foreign material.
Installation
1. Apply the foam strips from the service kit to the evaporator core.
2.
3.
4. NOTE: Install new O-ring seals.
Torque: 5 Nm
5. To install, reverse the removal procedure.
READ NEXT:
Evaporator RHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to c
Evaporator Temperature Sensor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Condenser TD4 2.2L Diesel
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur
SEE MORE:
Xenon lamps
High voltage is required to
ignite the
gas and metal vapour which are used
to power Xenon lamps. Contact with
this voltage can cause serious injury.
Replacement or maintenance of
Xenon lamps should only be carried
out by suitably qualified personnel.
Xenon lamp units operate at a very
hig
Surround camera system
The camera home page is accessed from the
Home menu screen. If Cameras has not been
set as a short cut, touch Extra features to
display the list.
With the engine running, the surround camera
system uses 5 discretely placed cameras to
assist in manoeuvring the vehicle.
1. Enlarge:
To enlarg
