Range Rover Evoque: Steering Column Switches
Torque Specifications
Steering Column Multifunction Switch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Removal of the windshield wiper switch assembly is identical to this procedure.
1.
2.
3.
4.
5.
Installation
1. To install, reverse the removal procedure.
Ignition Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3. CAUTION: LH illustration shown, RH is similar.
NOTE: The step must be carried out on both sides.
4.
5. Torque: 6 Nm
6.
7. Torque: 1.5 Nm
8.
Installation
1. To install, reverse the removal procedure.
Steering Column Lock Module
Removal
NOTES:
Removal steps in this procedure may contain installation details.
The steering column lock module is retained with 2 patch locked, tamper proof bolts.
1. Refer to: Steering Column (211-04 Steering Column, Removal and Installation).
2. Using a suitable stud extraction tool, remove the tamper proof bolts.
Installation
1. CAUTION: Tighten the new tamper proof bolts until the hexagon shears. To install, reverse the removal procedure.
2. Using the Land Rover approved diagnostic system, calibrate a new module.
3. If a new component is installed, the soft lock stop reset routine should be completed on the power steering system, using the approved diagnostic tool.
READ NEXT:
Engine System - General Information
Cylinder Head Gasket Selection TD4
2.2L Diesel
Special Tool(s)
303-979
Measuring Bridge, Piston Protusion
1. CAUTION: Make sure that the surface is clean and
free of foreign material.
Zero the gauge o
SEE MORE:
Points of interest (POI)
After selecting Points of interest from the
menu, touch Name to input the POI name, for
example, Petrol to display fuel stations on the
map, or touch List for a list of POIs.
Alternatively, choose Category to see all
categories of POI and make your selection.
Use the scroll arrows to change pa
Stalled adjustment
If seat
movement stops unexpectedly
during adjustment check for any
obstructions and remove.
Once any obstructions have been removed the
seat adjustment mechanism can be reset as
follows.
Operate the button again to continue the stalled
adjustment. When seat movement resumes
hold the butt
