Range Rover Evoque: Opening and closing the bonnet

Opening and closing the bonnet
Opening
1. Pull the bonnet release lever, located in the
left-hand front footwell.
2. Lift the bonnet safety catch lever, located
below the centre point of the bonnet, then
raise the bonnet.
Closing
Do not drive with the bonnet
retained
by the safety catch alone.
3. Lower the bonnet until the safety catch
engages. Using both hands, press the
bonnet down until the catches click. Check
that both catches are engaged by trying to
lift the front edge of the bonnet.
READ NEXT:
Fluids used in motor vehicles are poisonous
and should not be consumed or brought into
contact with open wounds.
For your own safety, always read and obey all
instructions printed on labels and co
Prolonged contact with engine oil may cause
serious skin disorders, including dermatitis
and cancer of the skin. Always wash
thoroughly after contact.
It is illegal to pollute drains,
water
co
Engine compartment overview
2.0L petrol engine
1. Brake/clutch fluid reservoir caps (beneath
covers):
A. Left-hand drive vehicles.
B. Right-hand drive vehicles.
2. Engine oil filler cap.
5. O
SEE MORE:
COMPONENT LOCATION
Instrument cluster
Hazard flasher switch
Rain/Light sensor
Rear height sensor (Xenon headlamps only)
Side turn signal indicator lamp
Headlamp leveling control module
CJB (central junction box)
Reverse lamp switch
Front height sensor (Xenon headlamps only)
Stop lamp swi
Engine Cover GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Do not disassemble further if the
component is removed for access only.
Installation
1. To install, reverse the removal procedure.
Engine Cover TD4 2.2L Diesel
Removal
1. Torqu
© 2011-2025 Copyright www.rrevoque.org
