Range Rover Evoque: Rear seat access (coupe models)

The front seats tilt and power slide forwards for entry to and exit from the rear seats. Operation is controlled by a lever and switch.

1. Lift the locking lever and pivot the seatback

1. Lift the locking lever and pivot the seatback forwards.

2. Press the front of the switch to power the seat forwards.

3. To return the seat, pivot the seatback until it locks into its previous position, then press and hold the rear of the switch to power the seat rearwards until it locks into position.

READ NEXT:

 Rear seats

 Folding and raising the rear seats

Folding and raising the rear seats The split fold rear seat of 5 door models can be folded completely, or partially at 60/40 split, to accommodate loads and still retain seating for passengers.

 Rear seat head restraints

Adjust the head restraint so that the top of the head restraint is above the centre line of the head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the

SEE MORE:

  Using cruise control

Using cruise control 1. Set target speed, or increase speed. 2. RES. Resume set speed. 3. CAN. Suspends cruise control operation without erasing memorised speed. 4. Decrease set speed. Note: Cruise control is not available when using Hill Descent Control or when a Terrain Response special

  Set or increase cruise speed

When setting the cruise control to the speed limit, it is important to remember that it is possible for the vehicle speed to increase when travelling downhill. This may result in the vehicle speed exceeding the speed limit. Note: Cruise control can be engaged only at speeds in excess of 30

© 2011-2026 Copyright www.rrevoque.org - 0.0053