Range Rover Evoque: Replacing remote control batteries

Replacing remote control batteries
With the back of the remote control facing
upwards, use a coin or similar implement to
rotate the battery cover. Lift the cover off to
reveal the battery compartment. Remove the
old battery and, ensuring that the correct
polarity is maintained, insert a replacement 3.3
volt, CR1/3N battery. Replace the cover and
rotate it to lock it closed.
READ NEXT:
A maximum of three controls can be
programmed to each vehicle. Contact your
Land Rover dealer to purchase additional units
and have them programmed to your vehicle.
Cup holders and storage
1. Glovebox.
2. Inside the glovebox is a drop down storage
area for the Owner’s Handbook pack.
3. Cubby box.
4. Sliding top to reveal cup holders.
Do not drink, or u
SEE MORE:
Check the engine oil weekly.
If any
significant or sudden drop in oil level is
noted, seek qualified assistance.
Never allow the oil level to fall below the
lower mark or notch on the dipstick.
If the message ENGINE OIL PRESSURE
LOW is displayed, stop the engine as
soon as it is safe to do
Remove the spare wheel prior
to
jacking the vehicle, to avoid
destabilising the vehicle when raised.
Do not use power tools to
loosen the
spare wheel. Doing so may damage the
mechanism.
1. To access the temporary spare wheel, fold
forward the rear edge of the cover then
remove it.
2.
© 2011-2025 Copyright www.rrevoque.org
