Range Rover Evoque: Rolling code device equipment programming
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage door opener receiver (motor
head unit) in the garage, locate the learn or
smart button/switch.
- The name of the button or switch may
vary between manufacturers.
2. Press and release the learn or smart
button.
3. In your vehicle, firmly press the previously
programmed HomeLink opener button
twice and release.
4. Press and hold briefly to complete the
programming process.
HomeLink should now activate the rolling code
device.
READ NEXT:
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep th
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
SEE MORE:
Crash statistics show that
children are
safest when properly restrained in a
child or infant restraint system that is
secured in a rear seating position.
Information given within the
table is
correct at the time of going to press.
However, availability of child restraints
may change. Pl
Changing a road wheel
1. Temporary spare wheel locking ring.
2. Temporary spare wheel retaining bolt.
3. Tool kit retaining bolt.
4. Jack.
5. Wheel brace.
After use, the tool kit
should be
returned to the under floor storage
area and correctly stowed.
The spare wheel is heavy and if
h
© 2011-2025 Copyright www.rrevoque.org
