Range Rover Evoque: Airbag service information
Do not attempt to service,
repair,
replace, modify, or tamper with, any
part of the SRS. This includes wiring
or components in the vicinity of SRS
components. Doing so may cause the
system to trigger, or render the
system inoperative.
Do not use any electrical test
equipment or devices in the vicinity of
SRS components or wiring. Doing so
may cause the system to trigger, or
render the system inoperative.
All of the following operations should be
carried out only by a Dealer/Authorised
Repairer, or suitably qualified person:
- Removal or repair of any wiring or
component in the vicinity of any SRS
components.
- Installation of electrical, or electronic, equipment and accessories.
- Modification to the front or sides of the vehicle exterior.
- Attachment of accessories to the front or sides of the vehicle.
READ NEXT:
Disability modifications
Occupants with disabilities which may require
modification of the vehicle, must contact a
Dealer/Authorised Repairer before any
modifications are made.
Lighting control
Lighting control
1. With the headlamps on, push the control
away from the steering wheel to select high
beam. The instrument pack warning lamp
will illuminate.
Note: Do not use high beam where
SEE MORE:
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd or reverse gears.
Automatic transmission: HDC can be used in
D, R and CommandShift 1, 2 or 3.
Note
Lumbar Assembly Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and
