Range Rover Evoque: Blower Motor LHD AWD/LHD FWD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES: Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. NOTE: The recirculation blend door must be closed in order for the removal of the recirculation blend door housing. Activate recirculation.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).
4. Refer to: Central Junction Box (CJB) (418-00 Module Communications Network, Removal and Installation).
5.
6.
7.
8. Torque: 10 Nm
9.
10.
11.
12.
13. Special Tool(s): 412-140
14.
15. CAUTION: Make sure that the special tool is correctly located.
NOTE: With assistance remove the component.
Installation
1.
2.
3. To install, reverse the removal procedure.
READ NEXT:
Blower Motor RHD AWD/RHD FWD, RHD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essenti
Climate Control Assembly
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: LH illustration shown, RH is similar.
NOTE: The procedure must be carried out on both
sides.
Evaporator LHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to c
SEE MORE:
Four-Wheel Drive Systems
Four-Wheel Drive Systems - Component Location
NOTE: Automatic transmission shown, manual transmission similar
Transmission
Power transfer unit
Four-Wheel Drive Systems - Overview
OVERVIEW
The power transfer unit is located at the rear of the engine and is attached
directly to the transmission
Transfer Case Fluid
Level Check
CAUTION: The fluid filler plug is not a fluid level plug.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Fron
