Range Rover Evoque manuals

Range Rover Evoque: Engine Upper/Lower Support Insulator

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Engine Upper/Lower Support Insulator

Engine Upper Support Insulator

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Some variation in the illustrations may occur, but the essential information is always correct.

1. Refer to: Engine Mount RH (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

2. Torque: 10 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

3. Torque: 80 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. To install, reverse the removal procedure.

Engine Lower Support Insulator

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).

3. CAUTION: Discard the bolts.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

4. CAUTION: Discard the bolt.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. CAUTIONS:

Make sure that a new bolt is installed.

Only tighten the bolt finger-tight at this stage.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

2. CAUTIONS:

Make sure that new bolts are installed.

Install all the bolts finger tight before final tightening.

Torque:

READ NEXT:

 Oil Filter Housing

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Balance Shaft Assembly

Special Tool(s) JLR-303-1595 Alignment Tool, Crankshaft Damper Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essent

 Engine - Diagnosis and Testing

Principles of Operation For a detailed description of the engine system, refer to the relevant Description and Operation section in the workshop manual. REFER to: (303-01B Engine - GTDi 2.0L Petrol)

SEE MORE:

 Power Brake Actuation

Brake Booster - Component Location COMPONENT LOCATION - 2.2L Td4 NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar Brake booster Vacuum pipe (vehicles with stop/start system) Vacuum pump Vacuum pipe (vehicles without stop/start system) Non return val

 Rocker Panel

Removal NOTES: The rocker panel is manufactured from mild steel. Some of the butt joints must be MIG brazed due to the location of boron reinforcements. 1. This procedure identifies the method for the replacement of the rocker panel in full. The graphic and table identify possible alternative sec

© 2011-2025 Copyright www.rrevoque.org