Range Rover Evoque: Instrument Panel Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. NOTE: The procedure must be carried out on both sides. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
4. Refer to: Steering Column (211-04 Steering Column, Removal and Installation).
5. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
6. Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation).
7. NOTES:
The step must be carried out on both sides.
LH illustration shown, RH is similar.
Torque:
Screw 17mm 1.9 Nm
Screw 13mm 1.1 Nm
8.
9. Torque: 1 Nm
10.
11. Torque: 1.5 Nm
12. CAUTION: Take extra care not to damage the instrument cluster face.
13.
14. Torque: 6 Nm
15.
16. CAUTION: Care must be taken to avoid damage to the internal components of the center registers.
Torque: 1.5 Nm
17. Torque: 1.5 Nm
18.
19.
20. Torque: 6 Nm
21. CAUTION: Protect the surrounding trim to avoid damage.
NOTE: With assistance remove the component.
Torque: 6 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Floor Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. NOTES:
The
Overhead Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: Take extra care not to damage the
edges of the component.
2.
3. NOTE: Do not disassemble further if the
co
Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on
both sides.
NOTE: LH illustration shown, RH is similar.
T
SEE MORE:
Voice tutorial
To listen to a tutorial detailing the operation of
the Voice system:
- Briefly press the Voice button to start a
voice session.
- Wait for the tone to sound, then say Voice
tutorial.
Alternatively, the tutorial can be selected using
the touch screen, as follows.
- Select Setup from the touch
Steering Linkage
Tie Rod End
Special Tool(s)
205-754A
Splitter, Ball Joints
Removal
NOTE: RH illustration shown, LH is similar.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and
Installation).
3.
4. CAUTIO
