Range Rover Evoque: Replacement sensor
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Tyre pressure monitoring system / Replacement sensor
Should the sensor require replacing, it should be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a running wheel in order to be recognised by the system. The vehicle needs to be stationary for 15 minutes during the sensor fitment before the system is ready to detect the new sensor.
The vehicle must be driven for a minimum of fifteen minutes after the sensor change, and then remain stationary for fifteen minutes to activate full TPM system operation.
If the TPM system warning for any wheel does not clear, even after ensuring correct inflation and driving for more than ten minutes above 25 km/h (18 mph), you should seek qualified assistance as soon as possible.
READ NEXT:
Tyre repair kit
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
Safety information
Some tyre damage may only be
partially sealed, or may not seal at
all, depending on the amount and type
of damage. Any loss of tyre pressure
can seriously affect vehicle safety.
Do not use the t
SEE MORE:
Fuel Tank and Lines - Component
Location
Component
Location
COMPONENT LOCATION - ROW
Connection to purge valve
Fuel Low Pressure (LP) sensor
Fuel fired booster heater - fuel supply pipe connection (if fitted)
LP fuel supply pipe
Fuel fired booster heater - fuel supply pipe (if fitted)
Fuel pump delivery module
Fuel tank breather p
Fuel Tank and Lines - System
Operation and Component Description
Control Diagram
NOTE: A = Hardwired
Battery
Battery Junction Box (BJB)
Fuel Pump Driver Module (FPDM)
Fuel pump delivery module
Engine Control Module (ECM)
Central Junction Box (CJB)
System Operation
OPERATION
The 2.0L GTDi fuel system uses a returnless fuel system. The fuel pump
operation
© 2011-2026 Copyright www.rrevoque.org - 0.0039
