Range Rover Evoque: Restraints Control Module (RCM)

Removal

NOTES:

The RCM must be replaced after every time any SRS component has been deployed.

Removal steps in this procedure may contain installation details.

1. Make the SRS system safe.

Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).

4. Torque: 10 Nm

Range Rover Evoque. Supplemental Restraint System

Installation

1. CAUTION: If a new component has been installed, configure using Land Rover approved diagnostic equipment. To install, reverse the removal procedure.

Driver Air Bag Module

Removal

1. Make the SRS system safe.

Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).

2.

Range Rover Evoque. Supplemental Restraint System

3.

Range Rover Evoque. Supplemental Restraint System

4.

Range Rover Evoque. Supplemental Restraint System

5. CAUTION: Take extra care not to damage the wiring harnesses.

Range Rover Evoque. Supplemental Restraint System

Installation

1. CAUTION: Take extra care not to damage the wiring harnesses.

Range Rover Evoque. Supplemental Restraint System

2. WARNING: Driver air bag module installation can be confirmed by hearing 3 audible clicks, 1 for each clip.

CAUTION: Make sure the wiring harness is installed to its original position.

Range Rover Evoque. Supplemental Restraint System

3. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

Driver Lower Air Bag Module

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Make the SRS system safe.

Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).

2.

Range Rover Evoque. Supplemental Restraint System

3.

Range Rover Evoque. Supplemental Restraint System

4.

Range Rover Evoque. Supplemental Restraint System

5.

Range Rover Evoque. Supplemental Restraint System

6. Torque: 6 Nm

Range Rover Evoque. Supplemental Restraint System

7.

Range Rover Evoque. Supplemental Restraint System

8.

Range Rover Evoque. Supplemental Restraint System

9. Torque:

M6 bolt 6 Nm
Screw 8 Nm

Range Rover Evoque. Supplemental Restraint System

10. Torque: 6 Nm

Range Rover Evoque. Supplemental Restraint System

11.

Range Rover Evoque. Supplemental Restraint System

12.

Range Rover Evoque. Supplemental Restraint System

13. Torque: 6 Nm

Range Rover Evoque. Supplemental Restraint System

14.

Range Rover Evoque. Supplemental Restraint System

Installation

1. To install, reverse the removal procedure.

Passenger Air Bag Module

Removal

WARNINGS:

It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first.

Never reverse connect the battery.

NOTES:

Removal steps in this procedure may contain installation details.

If the SRS component is to be replaced, the bar code of the new unit must be recorded.

1. Make the air bag supplemental restraint system (SRS) safe.

Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).

2. Disconnect both battery cables. Disconnect the ground cable first.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Instrument Panel Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

4. NOTE: LHD illustration shown, RHD is similar.

Range Rover Evoque. Supplemental Restraint System

5. NOTE: LHD illustration shown, RHD is similar. Torque: 4.8 Nm

Range Rover Evoque. Supplemental Restraint System

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Side Air Bag Module

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Descripti

 Side Air Curtain Module

Removal CAUTION: Do not allow the side air curtain module to twist. Failure to follow this instruction may result in damage to the component. NOTES: Removal steps in this procedure may contain instal

 Clockspring

Removal CAUTION: Make sure that the road wheels are in the straight ahead position. NOTE: Removal steps in this procedure may contain installation details. 1. Make the SRS system safe. Refer to: St

SEE MORE:

 Dsc warning lamp

The amber DSC warning lamp in the instrument panel illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC system is active. If the lamp illuminates continuously while driving, there is a fault with the DS

 Tyre pressure monitoring (TPM) system

The TPM system provides a low pressure warning and does not re-inflate your tyres. Tyre pressures should be checked regularly using an accurate pressure gauge when cold. The TPM system can NOT register damage to a tyre. Regularly check the condition of your tyres, especially if the vehicle

© 2011-2025 Copyright www.rrevoque.org