Range Rover Evoque: Steering Column Switches
Torque Specifications
Steering Column Multifunction Switch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Removal of the windshield wiper switch assembly is identical to this procedure.
1.
2.
3.
4.
5.
Installation
1. To install, reverse the removal procedure.
Ignition Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3. CAUTION: LH illustration shown, RH is similar.
NOTE: The step must be carried out on both sides.
4.
5. Torque: 6 Nm
6.
7. Torque: 1.5 Nm
8.
Installation
1. To install, reverse the removal procedure.
Steering Column Lock Module
Removal
NOTES:
Removal steps in this procedure may contain installation details.
The steering column lock module is retained with 2 patch locked, tamper proof bolts.
1. Refer to: Steering Column (211-04 Steering Column, Removal and Installation).
2. Using a suitable stud extraction tool, remove the tamper proof bolts.
Installation
1. CAUTION: Tighten the new tamper proof bolts until the hexagon shears. To install, reverse the removal procedure.
2. Using the Land Rover approved diagnostic system, calibrate a new module.
3. If a new component is installed, the soft lock stop reset routine should be completed on the power steering system, using the approved diagnostic tool.
READ NEXT:
Engine System - General Information
Cylinder Head Gasket Selection TD4
2.2L Diesel
Special Tool(s)
303-979
Measuring Bridge, Piston Protusion
1. CAUTION: Make sure that the surface is clean and
free of foreign material.
Zero the gauge o
SEE MORE:
Rear Quarter Window Glass 3-Door
Removal
1. Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and
Ornamentation, Removal and Installation).
2. Refer to: B-Pillar Upper Trim Panel - 3-Door (501-05 Interior Trim and
Ornamentation, Removal and Installation).
3. Refer to: D-Pillar Trim Panel (501-05 Interior Trim and
Ornament
Anti-lock Braking System (ABS)
Anti-lock Braking Control Module (ABS)
CAUTION: Diagnosis
by substitution from a donor vehicle is NOT acceptable. Substitution of control
modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOTES:
If the
