Range Rover Evoque: Suspending and resuming cruise control

Suspend cruise control with a single press of control (3).

To resume cruise control at the previous set speed, press control (2).

if the RES (2) should be used only if the driver is aware of the set speed and intends to return to it.
It is not recommended to resume set speed when a low gear is selected as excessive engine speeds will occur.

READ NEXT:

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

 Stability control

SEE MORE:

 Parking Aid - Overview

OVERVIEW The parking aid system provides an audible warning to the driver when any obstacles are in the path of the vehicle during forward or reverse parking maneuvers. The system consists of four ultrasonic sensors in the front bumper and four ultrasonic sensors in the rear bumper, a parking aid

 Driver/Passenger Seat Module (DSM/PSM)

 CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle  NOTES: If the control module or a component

© 2011-2025 Copyright www.rrevoque.org