Range Rover Evoque: Front Seat Height Adjustment Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: To avoid accidental deployment, the restraints control module backup power supply must be depleted. Wait at least two minutes after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any component(s) adjacent to the SRS sensors.
Failure to follow these instructions may result in personal injury.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. Refer to: Front Seat Control Switch (501-10 Seating, Removal and Installation).
4. Refer to: Front Seat (501-10 Seating, Removal and Installation).
5. CAUTION: Note the fitted position of the component prior to removal.
Vehicles with sports seats
6.
7. CAUTION: Note the fitted position of the component prior to removal.
Vehicles with heated front seats
8. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Non NAS vehicles
9. CAUTION: Make sure that the component is aligned and attached as shown.
NAS vehicles
10.
All vehicles
11. NOTE: If equipped.
12.
13.
14. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
Torque: 28 Nm
15. Torque: 28 Nm
16. NOTES:
Use a suitable tool to remove the circlips from the seat cushion frame bolts.
Note the orientation of the components.
Right-hand shown, left-hand similar.
Repeat the procedure for the other side.
17. NOTES:
Right-hand shown, left-hand similar.
Repeat the procedure for the other side.
Torque: 20 Nm
18.
19. NOTES:
Note the orientation of the components.
Right-hand shown, left-hand similar.
20.
21. Torque: 10 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Front Seat Cushion Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on
Rear Seat Cushion Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on how to correc
Front Seat Backrest Heater Mat
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
SEE MORE:
Rear Inner Quarter Panel
Removal
NOTES:
The rear inner quarter panel is manufactured from mild steel.
The rear inner quarter panel is unpicked from the inner quarter panel, it is not
serviced separately.
There are NVH components on this panel, they are not serviced on the new panel.
If damaged, new components will
be re
Using wheel chocks
Note: Wheel chocks are not supplied as part of
the tool kit.
Wheel chocks are a useful addition to a vehicle
tool kit. Note the following advice when using
wheel chocks.
Before raising the vehicle,
the wheel
diagonally opposite the one to be
removed must be chocked.
Always chock the wheel
