Range Rover Evoque: Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode.

When the pedal is relaxed, normal gear changing will resume.

READ NEXT:

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

 Transmission fault

In the event that the transmission develops a fault, a warning message may be displayed in the message centre and only limited gears may become available. You should seek qualified assistance imme

SEE MORE:

 Engine System - General Information

Cylinder Head Gasket Selection TD4 2.2L Diesel Special Tool(s) 303-979 Measuring Bridge, Piston Protusion 1. CAUTION: Make sure that the surface is clean and free of foreign material. Zero the gauge on the cylinder block machined face. Special Tool(s): 303-979 2. CAUTION: Make sure that the surfac

 Dual view selection

When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view. To select dual view, press the dual view hard key on the fascia surround. See 111, AUDIO/VIDEO CONTROLS. Press again to display the dual view Options menu. From h

© 2011-2025 Copyright www.rrevoque.org