Range Rover Evoque: Rain sensor

switched off Ensure that the wipers are switched off before entering a car wash. If the rain sensitive wipers operate during the car washing process, damage may occur to the wiper mechanism.

The rain sensor is able to detect the presence and amount of rain/dirt/snow on the windscreen and automatically activates the windscreen wipers accordingly. Static droplets may not be detected on initial start-up, use a single wipe to clear the screen.

To activate the rain sensitivity wipers, move the wiper stalk to the rain sensor position (4). A single wipe will be actioned.

Adjust the rain sensitivity collar (1) as required.

Increasing sensitivity while position (4) is selected will action a single wipe.

If a front door is opened while the wipers are operating, the wipers will be disabled.

Operation will restart when the doors are closed again.

READ NEXT:

 Speed sensitive wipers

If vehicle speed drops below 6km/h (3.7mph) with the wipers operating in positions (2) or (3), the wipers will switch to the next lowest speed. When vehicle speed increases to over 6km/h (3.7mph),

 Drip wipe

If the drip wipe function is configured, the wipers will operate four seconds after a wash/wipe cycle has finished, to clear any remaining drips from the windscreen. This function can be enabled

 Winter park position

The wipers can be set to park in a higher position than normal. This allows the blades to be lifted from the screen to prevent freezing. The ‘Wipers winter park’ option can be selected from th

SEE MORE:

 Information and Message Center

Information and Message Center - Component Location COMPONENT LOCATION Information and Message Center - Overview OVERVIEW The message center is located in the instrument cluster, in a central position between speedometer and the tachometer. The 5 inch Thin Film Transistor (TFT) display can be cont

 Deselecting valet mode

If Valet mode is active when you enter the vehicle, touch the Valet button to view the Valet mode screen. Enter your four digit PIN and touch the OK button. Valet mode is deactivated is displayed. - The tailgate will return to the previously set security requirement. - All touch screen funct

© 2011-2025 Copyright www.rrevoque.org