Range Rover Evoque: Rear wiper
If reverse gear is selected while the front wipers are operating, the rear wiper will start automatically and continue as long as reverse gear is selected. The wipe interval is dependent on the front wipers setting.
If reverse gear is selected while the rear wiper control is in the INT position, the wiper will operate for a single sweep of the rear screen.
When stationary, if the tailgate is opened while the rear wiper is operating, the wiper will stop.
When the tailgate is closed, the wiper will start to operate again after a delay of three seconds.
If the tailgate is open and vehicle speed is above 3km/h (2mph) the wiper will operate normally.
READ NEXT:
Wiper blade replacement
This subject is covered in the Maintenance
section. See 175, WIPER BLADE
REPLACEMENT.
Electric windows and panoramic roof blind
Electric windows and panoramic roof blind
1. Briefly pull a switch fully up and release,
the window will continue to rise until fully
closed. Briefly press a switch fully down
and release, the w
SEE MORE:
Evaporator RHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to cover this
procedure.
Removal steps in this procedure may contain installation details.
All vehicle
Evaporator Temperature Sensor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installa
© 2011-2026 Copyright www.rrevoque.org - 0.0048
