Range Rover Evoque: Side Air Bag Module
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Front Seat Control Switch (501-10 Seating, Removal and Installation).
4. Refer to: Front Seat (501-10 Seating, Removal and Installation).
5. NOTE: If equipped.
6.
7.
8.
9. NOTE: Release the 2 clips located on the underside of the front seat.
10.
11.
12.
3-door
13.
14.
All vehicles
15.
16.
17.
18. WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
19. WARNING: Make sure that the air bag is correctly installed in to the fabric chute. Failure to follow this instruction may result in incorrect operation of the air bag.
Torque: 7 Nm
20.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Side Air Curtain Module
Removal
CAUTION: Do not allow the side air curtain module to twist. Failure to
follow this instruction may result in damage to
the component.
NOTES:
Removal steps in this procedure may contain instal
Clockspring
Removal
CAUTION: Make sure that the road wheels are in the straight ahead
position.
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: St
Air Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS)
Principle of Operation
For a detailed description of the supplemental restraints system and
operation, refer to the relevant Description and
Operation section in the workshop manual. REFER to: (501-2
SEE MORE:
Active
On-demand Coupling Control Module
Rear Differential Control Module (RDCM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOT
Roof Front Panel Vehicles With: Sliding
Roof Opening Panel
Removal
NOTES:
The roof front panel is manufactured from mild steel.
The 4 x screw in studs must be replaced in the installation of the roof front
panel.
1. The roof front panel is replaced in conjunction with:
Windshield
Headliner
Moonroof
2. For additional information relating to this repa
