Range Rover Evoque: Switching off the engine with the vehicle moving
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Switching off the engine with the vehicle moving
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation arise, then the following procedure applies.
- Press and hold the engine START/STOP button for 2 seconds, or; - Press the engine START/STOP button twice within 2 seconds.
In either case, the warning Engine Stop Button Pressed will be displayed in the message centre.
READ NEXT:
Rolling re-start
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the en
Keyless start backup
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start t
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
SEE MORE:
Automatic switch off
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park or Reverse gear is selected
on vehicles with automatic transmission.
- Dynamic Stability Control
Shock Absorber and Spring Assembly Vehicles With:
Dynamic Suspension
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTE: Some variation in the illustratio
© 2011-2025 Copyright www.rrevoque.org
