Range Rover Evoque: Transfer Case Seal LH GTDi 2.0L Petrol

Special Tool(s)

100-012
Slide Hammer

205-873/1
Remover/Installer, Transfer Case Seal

205-873/2
Protector, Transfer Case Seal

205-873/3
Punch/Screws, Transfer Case Seal

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Some variation in the illustrations may occur, but the essential information is always correct.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Power Transfer Unit - GTDi 2.0L Petrol (308-07B Transfer Case - Vehicles With: AWF21 6-Speed Automatic Transmission/M66 6-Speed Manual Transmission AWD, Removal and Installation).

3. CAUTIONS: Take extra care not to damage the seal.

Inspect the seal, replace if damaged

4. CAUTIONS: Make sure that the area around the component is clean and free of foreign material.

Take extra care not to damage the mating faces.

• Special Tool(s): 205-873/1
• Special Tool(s): 205-873/2
• Special Tool(s): 205-873/3

5.

• Special Tool(s): 205-873/1
• Special Tool(s): 205-873/2
• Special Tool(s): 205-873/3

6.

• Special Tool(s): 205-873/1
• Special Tool(s): 205-873/2
• Special Tool(s): 205-873/3
• Special Tool(s): 100-012

Installation

1. CAUTION: A soft faced hammer should be used to avoid damaging the special tool and creating debris.

• Special Tool(s): 205-873/1
• Special Tool(s): 205-873/2
• Special Tool(s): 205-873/3

2. To install, reverse the removal procedure.

3. Refer to: Power Transfer Unit - GTDi 2.0L Petrol (308-07B Transfer Case - Vehicles With: AWF21 6-Speed Automatic Transmission/M66 6-Speed Manual Transmission AWD, Removal and Installation).

4. Check and top-up the transfer case fluid level.

Refer to: Transfer Case Fluid Level Check (308-07B Transfer Case - Vehicles With: AWF21 6-Speed Automatic Transmission/M66 6-Speed Manual Transmission AWD, General Procedures).

READ NEXT: