Range Rover Evoque: Tyre change
Valve stem seal, washer, nut,
valve core
and cap should be replaced at every tyre
change. Valve stem seal, washer and
nut must be replaced if valve retention
nut is loosened. Sensor units and nuts
must be refitted using correct torque
figures and associated profile. Damage
to the vehicle may result if these
precautions are not taken.
Any tyre changes must be carried out by a qualified technician. Great care must be taken during removal and refitting of tyres to avoid damaging the sensor.
READ NEXT:
Replacement sensor
Should the sensor require replacing, it should
be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a
running wheel in order to be recognised by the
system. The v
Tyre repair kit
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
SEE MORE:
Roof Panel Vehicles Without: Sliding
Roof Opening Panel
Removal
NOTES:
The roof panel is manufactured from aluminium 6111T4.
The screw in studs must be renewed with the installation of a new roof panel.
1. The roof panel is replaced in conjunction with:
Liftgate
Windshield
Headliner
2. For additional information relating to this repair procedure p
Front Seat Height Adjustment Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. WARNING: To avoid accidental deployment, the restraints
control module backup power
© 2011-2025 Copyright www.rrevoque.org
