Range Rover Evoque: Valve Cover
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is always correct.
Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).
3. Torque:
- Clamp 3.7 Nm
- Bolt 10 Nm
4.
5.
6.
7. WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and may ignite. Failure to follow these instructions may result in personal injury.
CAUTION: Be prepared to collect escaping fluids.
8.
9.
10. Torque: 8 Nm
11.
12.
13.
14.
15.
16.
17.
18. Torque: 8 Nm
19. Torque: 10 Nm
20. NOTES:
Do not disassemble further if the component is removed for access only.
The gaskets are to be reused unless damaged.
21.
22. Torque: 8 Nm
Installation
1. CAUTIONS:
Make sure the mating faces are clean, before the sealant is applied.
Apply sealant WSE-M4G323-A6 in a 4-7mm diameter on the cylinder head in the areas illustrated. Install the component immediately after applying the sealant without smearing the sealant.
2. CAUTION: Tighten the bolts in the sequence shown. To install, reverse the removal procedure.
READ NEXT:
Engine - Removal and Installation
Removal
Special Tool(s)
205-857
Remover, Halfshaft
1. Refer to: Battery Tray (414-01 Battery, Mounting and Cables,
Removal and Installation).
2. Refer to: Air Conditioning (A/C) System Recovery, Evacu
Engine Upper/Lower Support Insulator
Engine Upper Support Insulator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always
Oil Filter Housing
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
SEE MORE:
Petrol and Petrol-Ethanol Fuel Systems Health and
Safety Precautions
WARNINGS:
Fuel may not give adequate warning before toxic or harmful effects arise.
Exposure to fuel can be harmful and can cause severe health damage or death.
Extreme care must be exercised when handling hot fluids. Always wash off spilled
fluids from affected areas of skin
immediately.
Hig
Supplemental Restraint System (SRS) Health and
Safety Precautions
WARNINGS:
Only qualified technicians are allowed to work on pyrotechnic components.
INHALED: Exposure to pyrotechnic residue may cause low blood pressure, severe
headache, irritation of mucous
membranes, fainting, shortness of breath or rapid pulse. Move a victim to fresh
air. Seek immediate m
