Range Rover Evoque: Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine.

1. A valid Smart Key must be inside the vehicle.

2. Fully depress the clutch pedal.

3. Press and release the start button. For diesel engined vehicles there may be a delay while the glow plugs warm up, then the engine will crank automatically until it starts.

READ NEXT:

 If the engine fails to start

Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance. If the engine fails to crank, or fails to start, consult

 Switching off the engine

Before switching off the engine, ensure that the vehicle is parked safely with the park brake applied. 1. Select P for automatic transmission, or neutral for manual transmissions. Note: If any ot

 Switching off the engine with the vehicle moving

It is not advisable to switch off the engine while the vehicle is moving. However, should such a situation arise, then the following procedure applies. - Press and hold the engine START/STOP

SEE MORE:

 Evaporator LHD

Removal NOTES: The removal of this component involves cutting an aperture in the evaporator housing wall and cutting through the high and low pressure A/C lines. A service repair kit is supplied to cover this procedure. Removal steps in this procedure may contain installation details. 1. Disconne

 Four-Wheel Drive Systems

Four-Wheel Drive Systems - Component Location NOTE: Automatic transmission shown, manual transmission similar Transmission Power transfer unit Four-Wheel Drive Systems - Overview OVERVIEW The power transfer unit is located at the rear of the engine and is attached directly to the transmission

© 2011-2025 Copyright www.rrevoque.org