Range Rover Evoque manuals

Range Rover Evoque: Front/Rear Door Window Glass

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Glass, Frames and Mechanisms / Front/Rear Door Window Glass

Front Door Window Glass

Special Tool(s)

Range Rover Evoque. Glass, Frames and Mechanisms501-114
Release Lever, Door Glass

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Torque: 1 Nm

Range Rover Evoque. Glass, Frames and Mechanisms

2. Special Tool(s): 501-114

Range Rover Evoque. Glass, Frames and Mechanisms

3.

Range Rover Evoque. Glass, Frames and Mechanisms

Installation

1. NOTE: An audible click is heard when the clips are fully latched.

To install, reverse the removal procedure.

Rear Door Window Glass

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

2. Torque: 1 Nm

Range Rover Evoque. Glass, Frames and Mechanisms

3. Torque: 1.2 Nm

Range Rover Evoque. Glass, Frames and Mechanisms

4. NOTE: Loosen the lower bolt, but do not fully remove.

Torque: 1.2 Nm

Range Rover Evoque. Glass, Frames and Mechanisms

5.

Range Rover Evoque. Glass, Frames and Mechanisms

6.

Range Rover Evoque. Glass, Frames and Mechanisms

Installation

1. NOTE: An audible click is heard when the clips are fully latched.

To install, reverse the removal procedure.

READ NEXT:

 Rear Quarter Window Glass 3-Door

Removal 1. Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation). 2. Refer to: B-Pillar Upper Trim Panel - 3-Door (501-05 Interior Trim and Ornamenta

 Liftgate Window Glass

Removal 1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation). 2. 3. 4. CAUTION: The step must be carried out on both sides. 5. CAUTIONS: Protect the surroun

 Windshield Glass

Removal CAUTIONS: Always protect paintwork and glass when removing exterior components. Always protect the interior components when removing body glass. Lay the glass on felt covered supports. Do no

SEE MORE:

 Front Side Member and Suspension Top Mount Assembly

Removal NOTES: The front side member and suspension top mount assembly consists of the front side member closing panel, fender apron panel front reinforcement, fender apron lower panel, suspension top mount, and fender apron panel reinforcement. The front side member and suspension top mount is m

 Battery warning symbols

Do not allow any naked flames, or other sources of ignition near the battery as the battery may emit explosive gasses. Ensure that when working near, or handling the battery, suitable eye protection is worn. This will reduce the risk of eye damage caused by acid splashes. To prevent r

© 2011-2025 Copyright www.rrevoque.org