Range Rover Evoque: Front Shock Absorber Vehicles With: Dynamic Suspension
General Equipment
- Suspension Spring Compressor
- Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds the spring rating quoted in the Specifcations section.
Always follow the spring compressor manufacturer's instructions.
The spring is under extreme tension, care must be taken at all times. Failure to follow these instuctions may result in personal injury.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Make sure the correct vehicle suspension components are installed.
Refer to: Shock Absorber and Spring Assembly - Vehicles With: Dynamic Suspension (204-01 Front Suspension, Removal and Installation).
3.
4.
- General Equipment: Suspension Spring Compressor
- General Equipment: Vise
5.
6. WARNING: Make sure to support the shock absorber.
CAUTION: Discard the nut.
7.
8.
Installation
1. Make sure the correct vehicle suspension components are installed.
Refer to: Specifications (204-00 Suspension System - General Information, Specifications).
2. Inspect the component and install a new one if damaged.
3. Inspect the component and install a new one if damaged.
4. Inspect the component and install a new one if damaged.
5. Inspect the component and install a new one if damaged.
6. Inspect the component and install a new one if damaged.
7. Inspect the component and install a new one if damaged.
8. WARNING: Make sure to support the shock absorber.
CAUTIONS:
Make sure the component is aligned as shown.
Make sure that the spring is installed to the damper assembly with the paint marks (located on the spring) at the top.
9. WARNINGS:
Make sure that a new nut is installed.
Make sure to support the shock absorber.
Torque: 67 Nm
10. CAUTION: Make sure the components are aligned as shown.
11.
12.
13. CAUTION: Make sure the components are aligned as shown.
14. Install the spring and damper assembly.
Refer to: Shock Absorber and Spring Assembly - Vehicles With: Dynamic Suspension (204-01 Front Suspension, Removal and Installation).
15. Check the suspension system ride height.
READ NEXT:
Shock Absorber and Spring Assembly Vehicles With:
Dynamic Suspension
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTION: Nuts and bolts must be
Rear Suspension AWD
Component Location
RH (right-hand) spring and damper assembly
Stabilizer link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub
Longitudinal link
Rear transverse lin
SEE MORE:
Dual view control menu
Dual view control menu
1. Select to cancel dual view and revert to the
menu for the current video source (TV,
DVD).
Note: The preview screen will be
deactivated if the vehicle is moving.
2. Select to view a list of all available video
sources. Touch the relevant soft key to
select an alter
Opening and closing the bonnet
Opening and closing the bonnet
Opening
1. Pull the bonnet release lever, located in the
left-hand front footwell.
2. Lift the bonnet safety catch lever, located
below the centre point of the bonnet, then
raise the bonnet.
Closing
Do not drive with the bonnet
retained
by the safety catc
