Range Rover Evoque: Dual view control menu
Dual view control menu
1. Select to cancel dual view and revert to the menu for the current video source (TV, DVD).
Note: The preview screen will be deactivated if the vehicle is moving.
2. Select to view a list of all available video sources. Touch the relevant soft key to select an alternative source. The controls menu for that source will then be displayed.
3. Select to change the picture format (4:3, Zoom, 16:9). The next available format is displayed on the soft key.
4. Information on the current video source (e.g. TV channel and program name).
5. Select to switch the front passenger wireless headphone output on or off.
6. Select to cancel dual view: The touch screen reverts to the menu currently in use by the driver.
7. Select to retain audio for the video source while the display reverts to the menu currently in use by the driver.
8. Select to dismiss the dual view controls pop-up.
9. Seek up: Select to view the next channel on the channel list or the next track on CD or DVD.
10. Seek down: Select to view the previous channel on the channel list or the previous track on CD or DVD.
READ NEXT:
Dual view tv operation
If you would like to change the TV programme
while the vehicle is moving, there are two
methods available;
1. Press the dual view hardkey to display the
control menu.
Select an alternative channe
Dual view video operation
When the video programme begins play, a root
menu with information about the video
programme and its content will be displayed on
screen.
Note: Information and style may vary due to
differing vid
SEE MORE:
Liftgate Window Glass
Removal
1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation,
Removal and Installation).
2.
3.
4. CAUTION: The step must be carried out on both
sides.
5. CAUTIONS:
Protect the surrounding components.
Protect the surrounding paintwork to avoid
damage.
Use a glazing cutting wire to
A-Pillar Outer Panel
Removal
NOTES:
The A-pillar outer panel is manufactured from mild steel. The fender
mounting bracket is serviced on the new panel.
The upper and lower butt joint must be MIG brazed due to the location of a boron
reinforcement.
A new anti tamper VIN indentification decal will be required when rep
