Range Rover Evoque: Keyless start backup
If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start the engine.
The keyless start backup can only be used when the message Smart Key Not Found Refer to Handbook is displayed in the message centre.
Position the Smart Key against the underside of the steering column cover with the buttons facing downwards.
With the brake (Auto) or clutch (Man) pedal depressed, press and release the START/STOP button to start the engine.
When the engine starts, you no longer need to hold the Smart Key beneath the steering column.
Note: If the Smart Key is not recognised or the engine still fails to start, consult your Dealer/ Authorised Repairer.
Note: If the message Smart Key Not Detected is displayed, ensure that the key is being held in the correct position and try again.
READ NEXT:
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
Conditions preventing automatic engine stop
The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not re
Conditions causing automatic engine restart
The engine will automatically start if:<>
- climate control system demand increases
- the vehicle’s speed reaches approximately 4km/h (2.5mph)
- HDC or a Terrain Response special program ar
SEE MORE:
Manual Transmission/Transaxle External Controls
Torque Specifications
External Controls -
Component Location
COMPONENT LOCATION
Shift cables
Gear knob
Selector lever assembly
Selector lever mounting plate
External Controls -
Overview
OVERVIEW
The manual transmission external controls comprise a selector lever and two
shift cables. The se
To erase all programming
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep the buttons pressed until the
indicator lamp begins to flash (this will take
approximately 20 second
