Range Rover Evoque: Instrument Panel Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. NOTE: The procedure must be carried out on both sides. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
4. Refer to: Steering Column (211-04 Steering Column, Removal and Installation).
5. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
6. Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation).
7. NOTES:
The step must be carried out on both sides.
LH illustration shown, RH is similar.
Torque:
Screw 17mm 1.9 Nm
Screw 13mm 1.1 Nm
8.
9. Torque: 1 Nm
10.
11. Torque: 1.5 Nm
12. CAUTION: Take extra care not to damage the instrument cluster face.
13.
14. Torque: 6 Nm
15.
16. CAUTION: Care must be taken to avoid damage to the internal components of the center registers.
Torque: 1.5 Nm
17. Torque: 1.5 Nm
18.
19.
20. Torque: 6 Nm
21. CAUTION: Protect the surrounding trim to avoid damage.
NOTE: With assistance remove the component.
Torque: 6 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Floor Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. NOTES:
The
Overhead Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: Take extra care not to damage the
edges of the component.
2.
3. NOTE: Do not disassemble further if the
co
Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on
both sides.
NOTE: LH illustration shown, RH is similar.
T
SEE MORE:
Rear Bumper Mounting
Removal
NOTE: The rear bumper mounting is manufactured from mild steel.
1. In this procedure, to make sure the vehicle is correctly
aligned, it must be placed on an approved alignment
jig.
2. The rear bumper mounting is replaced in conjunction with:
Rear bumper cover
Rear bumper
Back panel
3.
Front Shock Absorber Vehicles With: Dynamic
Suspension
General Equipment
Suspension Spring Compressor
Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's instructions.
The spring is under extreme te
