Range Rover Evoque manuals

Range Rover Evoque: Oil Cooler

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Oil Cooler

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).

4. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L Petrol, General Procedures).

5. Refer to: Engine Cover - GTDi 2 0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

6.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7. CAUTION: Make sure that the area around the component is clean and free of foreign material.

READ NEXT:

 Oil Pan

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Oil Pump

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Timing Chain

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. 1. Refer to: Specifications

SEE MORE:

 Map split screen

Map split screen 1. TMC (Traffic Message Channel) information. 2. North is up. 3. Small compass display which always indicates North. 4. Next direction display. 5. Current vehicle position. 6. Vehicle direction arrow. 7. Split screen. 8. Split screen scale/zoom setting. 9. Current stree

 Front Bumper Mounting

Removal NOTE: The front bumper mounting is manufactured from HSLA300 and mild steel. 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The front bumper mounting is replaced in conjunction with: Front bumper cover Front bumper

© 2011-2025 Copyright www.rrevoque.org