Range Rover Evoque: Rear Bumper Mounting
Removal
NOTE: The rear bumper mounting is manufactured from mild steel.
1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig.
2. The rear bumper mounting is replaced in conjunction with:
- Rear bumper cover
- Rear bumper
- Back panel
3. For additional information relating to this repair procedure please see the following: For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operation) / Body Repairs (501-25A Body Repairs - General Information, Description and Operation) / Corrosion Protection (501-25B Body Repairs - Corrosion Protection, Description and Operation) / Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation) / Standard Workshop Practices (100-00 General Information, Description and Operation).
4. Remove the back panel.
For additional information, refer to: Back Panel (501-30A Rear End Sheet Metal Repairs - 3-Door, Removal and Installation).
5. Drill 5. out the spot welds.
6. Separate the joints and remove the old panel.
Installation
1. Prepare the old and new panel joint surfaces.
2. NOTE: With panel in position check for access to spot weld the joints. Offer up the new panel and clamp into position. Check alignment, if correct, proceed to next step, if not, rectify and recheck before proceeding.
3. Remove the new panel.
4. NOTE: The graphic shows all joints, only drill for MIG plug welds where there is no access to spot weld. Drill holes in new panel ready for MIG plug welding.
5. Deburr MIG plug locations in new panel.
6. Offer up the new panel and clamp into position. Check alignment, if correct, proceed to next step, if not, rectify and recheck before proceeding.
7. NOTE: MIG plug welds can be substituted for spot welds if access is insufficient. Spot weld and MIG plug weld where required.
8. Dress all welds.
9. Apply a zinc rich primer to any bare metal surfaces at this stage.
10. NOTE: Make sure all underbody joints are sealed following this repair procedure
The installation of associated panels and mechanical components is the reverse of removal.
READ NEXT:
Back Panel
Removal
NOTES:
The back panel is manufactured from mild steel, it includes the bumper
retaining bracket.
It is necessary to remove a section of both rear lamp mounting panels to enable
removal and
Rear Side Member Lower Side Extension
Removal
NOTE: The rear side member lower side extension is manufactured from mild
steel.
1. The rear side member lower side extension is replaced in
conjunction with:
Rear bumper cover
Rear bumper
Rear Lamp Mounting Panel
Removal
NOTES:
The rear lamp mounting panel is manufactured from mild steel.
The section of the rear lamp mounting panel described within this procedure is
for the access for installation of the
inn
SEE MORE:
Front Seat Recliner Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
3. Refer to: Front Seat Co
Rear Seat Backrest Cover 5-Door
Removal
NOTES:
This procedure covers the removal and installation of both rear seat
backrests and the LH rear seat backrest cover.
The RH rear seat backrest cover is similar. All notes and cautions must be
followed strictly to avoid any chance of NVH or
failure of the rear seat backrests.
Some v
