Range Rover Evoque: Keyless entry
Keyless entry allows the vehicle to be opened if a Smart Key is within 1.0m (3ft) of the door handle or the tailgate external switch.
The Smart Key may not be detected if it
is placed within a metal container or if it
is shielded by a device with a back-lit
LCD screen, such as a smart phone,
laptop (including laptop bag), games
console etc. Keep the Smart Key clear of
such devices when attempting Keyless
entry or Keyless starting.
Note: The Smart Key needs only to be on the driver’s person or in a non-metallic bag or briefcase. It does not need to be exposed or handled.
When keyless entry operates, the alarm will be disarmed and the doors unlocked according to the current unlock/entry setting (Single or Multi-Point). The hazard warning lamps will flash twice as ‘unlock’ confirmation. Power folded mirrors will fold out (if enabled).
Note: If Single Point Entry is the current security setting and a door other than the driver’s door is opened first, all doors will unlock.
READ NEXT:
Smart key check
If the ignition is on or the engine is running and
there is no Smart Key inside the vehicle when
the last door is closed, the message Smart Key
Not Found Refer to Handbook will be displayed
in the
Disarming if the smart key and keyless entry fail to work
The vehicle can still be unlocked and the alarm
disabled. To unlock the vehicle:
1. Unlock the left side front door using the
key blade. The alarm will be triggered.
2. Position the Smart Key agai
Deactivating the alarm when triggered
If the alarm has been triggered, it can be
deactivated by any one of the following
methods:
- Pressing the unlock button on the Smart
Key.
- Opening a door using keyless entry.
- Positioning a v
SEE MORE:
Instrument Cluster
Instrument Cluster - Component Location
COMPONENT LOCATION
Instrument Cluster - Overview
OVERVIEW
The instrument cluster comprises two analogue gages for the speedometer and
the tachometer and a 5 inch Thin Film
Transistor (TFT) display for driver information.
The analogue gages are electronicall
Rear Side Member Closing Panel
Removal
NOTES:
The rear side member lower side extension is manufactured from DP600 with
a mild steel mounting bracket.
The panel is serviced less its weld studs.
1. The rear side
member closing
panel is replaced
2. For additional information relating to this repair procedure please see
the foll
