Range Rover Evoque: Parking aids
Parking aids
1. Parking aid on/off switch. The switch indicator will illuminate.
When reverse gear is selected, the front and rear parking sensors are activated automatically.
To turn off, press the button. The indicator will extinguish.
2. Approximate sensor range -600mm (24in).
3. Approximate sensor range -1500mm (60in).
It remains the driver’s
responsibility
to detect obstacles and estimate the
vehicle’s distance from them. Some
overhanging objects, barriers, chain
link fences, small children, animals,
thin obstructions or painted surfaces
may not be detected by the system.
Systems using the same
frequency
band as the front parking sensors, may
cause irregular tones to be emitted.
Front sensors will remain active as long as the vehicle's speed does not exceed 16km/h (10mph).
With automatic transmission, selecting N from R will keep front and rear sensors active.
When objects are detected, the parking aid emits a warning tone which increases in frequency as the vehicle gets closer to the object and then becomes constant when the obstacle is within 300mm (12in).
Note: The front parking aid provides an audible proximity warning when driving forwards and when reversing.
READ NEXT:
Towing
The rear sensors are automatically disabled
when a trailer with an approved electrical
connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking aids sensors.
Cleaning the sensors
When washing the vehicle do
not aim
high pressure water jets directly at the
sensors. Do not use abrasive materials
or hard/sharp objects to clean the
sensors. Only use approved vehicle
shampo
System fault
If a system fault is detected, a long
high-pitched tone will sound and the switch
indicator will flash. A message will be displayed
in the message centre. Contact your Dealer/
Authorised Repairer
SEE MORE:
Drive Pinion Front Bearing
Special Tool(s)
100-012
Slide Hammer
205-067
Preload Gauge
308-615
Remover, Seals
JLR-205-972
Mounting Bracket, Rear Axle
JLR-205-984
Remover/Installer, Drive Pinion Nut
JLR-205-985
Remover, Drive Pinion Bearing
JLR-205-986
Installer, Drive Pinion Bearing
Removal
1. Raise and support the vehicle.
2.
Tether anchorage points (Australia only)
WARNING:
Child restraint anchorages
are designed to withstand only those
loads imposed by correctly fitted child
restraints. Under no circumstances
are they to be used for adult seat
belts, harnesses or for attaching other
items or equipment to the vehicle.
Always follow the child seat or
