Range Rover Evoque: System fault
If a fault with one of the radar sensors is detected, an amber warning indicator dot is displayed in the exterior mirror and the message BSM not available is displayed in the message centre.
Note: Even if the detected fault only affects the radar sensor on one side of the vehicle, the whole system is disabled. If the fault is temporary, the system will operate correctly once the engine has been switched off and then on again.
If a fault in the system occurs, consult your Dealer/Authorised Repairer.
READ NEXT:
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best
SEE MORE:
Electronic Engine Controls -
Component Location
Component Location
COMPONENT LOCATION - SHEET 1 OF 4
Fuel metering valve - HP Fuel pump
Camshaft Position (CMP) sensor (2 off)
Variable Camshaft Timing (VCT) solenoid (2 off)
Purge valve
Generator
Air Conditioning (A/C) compressor clutch
Crankshaft Position (CKP) sensor
Turbocharger wasteg
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect
Network (LIN) Bus
CONTROL DIAGRAM - SHEET 1 OF 2
Battery
Starter motor fuse
Battery Junction Box (BJB)
Starter motor
Generator
Transmission Control Module (TCM)
Cooling fan control module
Air Conditioning
© 2011-2026 Copyright www.rrevoque.org - 0.0041
