Range Rover Evoque: Temporary spare wheel
Always adhere to the
instructions
given on the temporary use spare
wheel warning label. Failure to
comply can be dangerous.
When a temporary use spare wheel is
fitted, drive with caution and replace
with the specified wheel and tyre as
soon as possible.
Do not fit more than one temporary
use spare wheel and tyre assembly at
one time.
The temporary use spare wheel must
be inflated to 4.2 bar (60 psi, 420 kPa)
and cannot be repaired.
Temporary use spare wheel,
maximum speed is 80 km/h (50 mph).
DSC must be switched on while the
temporary spare wheel is in use.
Traction devices such as snow chains
cannot be used with a temporary
spare wheel.
READ NEXT:
Note: Wheel chocks are not supplied as part of
the tool kit.
Wheel chocks are a useful addition to a vehicle
tool kit. Note the following advice when using
wheel chocks.
Before raising the vehic
Before raising the vehicle or changing a wheel,
ensure that you read and comply with the
following warnings.
Always find a safe place to
stop, off
the highway and away from traffic.
Ensure tha
Locking wheel nuts can be removed only by
using the special adapter provided in the tool
kit.
Note: When the vehicle is first supplied, the
adapter may be stored in the glove
compartment. It shou
SEE MORE:
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body.
The b-pillar outer panel is manufactured from mild steel.
The rocker panel butt joints must be MIG brazed due to the location of boron
reinforcements.
1. The B-Pillar outer panel is replaced in
Removal
NOTES:
The rear lamp mounting panel is manufactured from mild steel.
The section of the rear lamp mounting panel described within this procedure is
for the access for installation of the
inner back panel assembly.
The upper NVH component must be replaced when a complete panel is installed
© 2011-2025 Copyright www.rrevoque.org
