Range Rover Evoque: To erase all programming
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / To erase all programming
For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off).
2. Press and hold the two outer HomeLink buttons. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 seconds), then release the buttons.
All memories in HomeLink have now been cleared.
Note: Do not perform this procedure when programming the additional garage door opener buttons.
READ NEXT:
Entry gate programming
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
Information and assistance
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
Instrument panel
Instrument panel
1. Speedometer.
2. Driver Information Centre (message centre).
3. Tachometer.
4. Temperature gauge
Serious engine damage can
occur if
the vehicle is driven while the
engin
SEE MORE:
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6 inches) away from
the HomeLink transceiver in the rear-view
mirror, keeping the indicator lamp in
B-Pillar Lower Trim Panel, D-Pillar Trim Panel
B-Pillar Lower Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4. CAUTION: Discard the bolt.
Torque: 45 Nm
5.
6.
Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly
inst
© 2011-2025 Copyright www.rrevoque.org
