Range Rover Evoque: Stop/start (manual transmission only)

The Stop/Start system has been designed to improve fuel efficiency. The system is automatically activated when the ignition is switched on.

When the engine has been stopped by the stop/start system, the ECO icon will illuminate.

When the vehicle comes to a stop,

When the vehicle comes to a stop, neutral is selected and the clutch is fully released, the engine automatically switches off.

When the clutch is depressed prior to selecting a gear, the engine automatically restarts.

READ NEXT:

 Conditions preventing automatic engine stop

The engine will not automatically stop if:<> - the external temperature is below approximately 0°C (32°F) - the external temperature is above approximately40°C (104°F) - engine has not re

 Conditions causing automatic engine restart

The engine will automatically start if:<> - climate control system demand increases - the vehicle’s speed reaches approximately 4km/h (2.5mph) - HDC or a Terrain Response special program ar

 Disabling stop/start

Disabling stop/start To switch the system off (preventing automatic stop/start) press the ECO switch. The LED indicator will extinguish to confirm that the system is off. Note: The engine will

SEE MORE:

  Power Transfer Unit TD4 2.2L Diesel

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front Drive Halfshafts, Removal and Installation). 3. R

  Transfer Case Connecting Sleeve Seals GTDi 2.0L Petrol

Special Tool(s) 100-012 Slide Hammer 307-594 Installer, Seal 308-005 Remover, Axle oil seal Removal NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2.

© 2011-2026 Copyright www.rrevoque.org - 0.0032