Range Rover Evoque: Trailer levelling

To maintain vehicle stability, it is essential that the trailer is loaded so that it remains parallel to the ground. This is particularly important when towing twin axled trailers.

Vssential towing checks

READ NEXT:

 Trailer electrical connection

Connect only approved electrical circuits, which are in good condition, to the trailer socket. The vehicle connector provides a 5 amp output which must not be exceeded. An accessory harness ki

 Powered tailgate

When towing, ensure there is sufficient clearance before opening or closing the tailgate.

 Parking aids

The rear parking aids sensors are automatically disabled when a trailer with an approved electrical connector is connected. Note: Trailers fitted with LED lights will not disable the rear parking

SEE MORE:

 Desiccant Bag GTDi 2.0L Petrol

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Condenser - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation). 3. Torque: 11 Nm Installation 1

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

© 2011-2025 Copyright www.rrevoque.org