Range Rover Evoque: Automatic switch off
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Cruise control / Automatic switch off
Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park or Reverse gear is selected on vehicles with automatic transmission.
- Dynamic Stability Control is operating.
- The difference between the actual and set speed is too great.
- The vehicle reaches a speed of 170km/h (105.6mph).
- The accelerator pedal is used to accelerate beyond the set speed for too long a period.
Cruise control will switch off and clear the memory when: - The ignition system is switched off.
- A fault occurs. The cruise control system will switch off and cannot be used until the fault is cleared.
READ NEXT:
Cruise eco data
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH
Dynamic stability control (DSC)
DSC is automatically enabled each time the
engine is started, and is automatically enabled
by some of the Terrain response special
programs.
The vehicle is not designed
for
cornering at the sa
SEE MORE:
Intake Air Distribution and Filtering - GTDi 2.0L Petrol
Intake Air
Distribution and Filtering - Component Location
COMPONENT LOCATION
Purge hose from charcoal canister
Clean air purge hose
Clean air inlet ducts
Camshaft cover vent pipe connection
Sound generator duct
Sound generator
Air cleaner housing
Dirty air intake duct
Sound generator hos
Electric parking brake (EPD)
The parking brake operates on
the rear
wheels. Therefore, secure parking of
the vehicle is dependent on being on a
hard and stable surface.
Do not rely on the parking brake to
operate effectively, if the rear wheels
have been immersed in mud or water.
Note: If the vehicle is used in severe
© 2011-2025 Copyright www.rrevoque.org
