Range Rover Evoque: Head restraints
Adjust the head restraint so
that the
top of the head restraint is above the
centre line of the head. An incorrectly
adjusted head restraint increases the
risk of death or serious injury in the
event of a collision.
Do not drive, or carry passengers with
the head restraints removed from
occupied seats. The absence of a
correctly adjusted head restraint
increases the risk of neck injury in the
event of a collision.
Never adjust the head restraints while
the vehicle is in motion.
Always store a removed head restraint
securely.
1. Move the head restraint up or down to the required position.
2. Press the locking collar to adjust the restraint downwards.
Manual head restraints can be removed, if required. Raise the head restraint to its uppermost position and press the locking collar (3). Lift the restraint out of the seatback.
Note: Head restraints fitted with Rear seat entertainment screens must NOT be removed.
Ensure the head restraint is refitted before the seat is used by a passenger.
To refit the head restraint, ensure it is facing the correct direction, insert the stems of the head restraint into the sockets and push it downwards until at least the first click.
READ NEXT:
Integrated head restraints
Models with ‘sports’ seats have non adjustable
and non removable head restraints.
Rear seat access (coupe models)
The front seats tilt and power slide forwards for
entry to and exit from the rear seats. Operation
is controlled by a lever and switch.
1. Lift the locking lever and pivot the seatback
forwards.
SEE MORE:
Starting System - GTDi 2.0L Petrol
Starting System - Component
Location
COMPONENT LOCATION
Solenoid
12V supply from battery
Solenoid power supply from Battery Junction Box (BJB)
Starter motor
Pinion gear
Starting System - Overview
OVERVIEW
The starter motor is rated as 1.3 kW and is a Denso conventional design with
the motor
Headlamps
Moving the nearside headlamp unit to access
bulbs;
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
This will allow more room for
manoeuvrability.
3. Remove the four grille fixings.
4. Remove the two retaining bolts.
5. At the rear of the headlamp unit, p
