Range Rover Evoque manuals

Range Rover Evoque: Anti-Lock Control - Stability Assist

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Brake System / Anti-Lock Control - Stability Assist

Accelerometer

Removal

NOTES:

Removal steps in this procedure may contain installation details.

LHD illustration shown, RHD is similar.

Vehicles with automatic transmission

1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

2. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Vehicles with manual transmission

3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).

4.

Range Rover Evoque. Anti-Lock Control - Stability Assist

5.

Range Rover Evoque. Anti-Lock Control - Stability Assist

6. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Installation

1. To install, reverse the removal procedure.

2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

READ NEXT:

 Steering System

 Power Steering

 Power Steering AWD

Component Location Steering gear Rubber seal assembly Heat shield Overview The vehicle is fitted with EPS (electric power steering), provided by a ZF Servolectric steering gear unit with variab

SEE MORE:

 Stop/start (manual transmission only)

The Stop/Start system has been designed to improve fuel efficiency. The system is automatically activated when the ignition is switched on. When the engine has been stopped by the stop/start system, the ECO icon will illuminate. When the vehicle comes to a stop, neutral is selected and the

 Mislock

When locking the vehicle with the Smart Key, if one or more of the doors, the bonnet or the tailgate is not fully closed, or the ignition is ON, the vehicle will NOT lock and there will be an audible mislock error warning. The hazard warning lamps will NOT flash and the door mirrors (if enable

© 2011-2025 Copyright www.rrevoque.org