Range Rover Evoque: Attaching tether straps

1. Install the child restraint securely in one of the rear seating positions.

2. Pass the tether strap over the seat back and beneath the head restraint.

3. Attach the tether strap hook to the tether anchor point on the back of the seat.

Ensure that the tether strap hook is facing the correct way.

4. Tighten the tether strap according to the manufacturer's instructions.

READ NEXT:

 Airbag supplementary restraint system (SRS)

Airbag supplementary restraint system (SRS) 1. Front passenger’s airbag 2. Curtain airbags 3. Side airbags 4. Knee-bolster airbag 5. Driver’s airbag Note: The general location of airbags f

 Airbag operation

For the airbags to operate correctly the roof lining and door post trims must be in good condition, correctly fitted, and free from obstruction. Any damage, wear, or incorrect fitment should b

 Disabling the passenger airbag (not Australia)

Crash test data and statistics show that the safest place for a child to be restrained is in a child seat correctly fitted to the vehicle's rear seat. Do not use a child restraint on a seat pr

SEE MORE:

 Torque Converter Seal TD4 2.2L Diesel

Special Tool(s) 307-597 Installer, Torque Converter Seal 307-613 Holding Pins, Torque Converter Removal NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

 Transfer Case Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 100-012 Slide Hammer 303-1300 Remover, Crankshaft Seal 303-538 Remover/Installer, Crankshaft Oil Seal 307-594 Installer, Seal 307-595 Installer, Intermediate Shaft Seal 308-615 Remover, Seals Removal NOTE: Some variation in the illustrations may occur, but the essential information

© 2011-2025 Copyright www.rrevoque.org