Range Rover Evoque: Automatic switch off
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Cruise control / Automatic switch off
Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park or Reverse gear is selected on vehicles with automatic transmission.
- Dynamic Stability Control is operating.
- The difference between the actual and set speed is too great.
- The vehicle reaches a speed of 170km/h (105.6mph).
- The accelerator pedal is used to accelerate beyond the set speed for too long a period.
Cruise control will switch off and clear the memory when: - The ignition system is switched off.
- A fault occurs. The cruise control system will switch off and cannot be used until the fault is cleared.
READ NEXT:
Cruise eco data
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH
Dynamic stability control (DSC)
DSC is automatically enabled each time the
engine is started, and is automatically enabled
by some of the Terrain response special
programs.
The vehicle is not designed
for
cornering at the sa
SEE MORE:
Methanol
Wherever possible avoid
using fuel
containing methanol.
Some fuels contain methanol (Methyl or wood
alcohol). If you use fuels containing methanol
the fuels must also contain co-solvents and
corrosion inhibitors for methanol. Also, do not
use fuels which contain more than 3%
methanol even
Brake/clutch fluid check
Seek qualified assistance
immediately if brake pedal travel is
unusually long or if there is any
significant loss of brake fluid. Driving
under such conditions could result in
extended stopping distances or
complete brake failure.
Brake fluid is highly toxic - keep
containers sealed and out
© 2011-2025 Copyright www.rrevoque.org
