Range Rover Evoque: Bulb check
A warning lamp bulb check is initiated when the ignition system is switched on and lasts for 3 seconds (except for the airbag warning lamp which will remain on for 6 seconds). If any warning lamp remains on after this period, investigate the cause before driving.
Some warning lamps have associated messages displayed on the message centre.
Note: Not all warning lamps are included in the check (e.g. high beam headlamps and direction indicators).
READ NEXT:
Critical warning message (red)
Critical warning message (red)
Illuminates when a critical warning
message is available in the
message centre.
Low oil pressure (red)
Low oil pressure (red)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp remains on, flashes or
illuminates while driving, stop the v
Brake systems (red)
Brake systems (red)
Illuminates briefly when the
ignition is switched on. If the lamp
illuminates while driving, suspect
low brake fluid level or a fault with the
Electronic Brake Distribution
SEE MORE:
Drive Pinion Front Bearing
Special Tool(s)
100-012
Slide Hammer
205-067
Preload Gauge
308-615
Remover, Seals
JLR-205-972
Mounting Bracket, Rear Axle
JLR-205-984
Remover/Installer, Drive Pinion Nut
JLR-205-985
Remover, Drive Pinion Bearing
JLR-205-986
Installer, Drive Pinion Bearing
Removal
1. Raise and support the vehicle.
2.
Using the repair kit
Avoid skin contact with the
sealant
which contains natural rubber latex.
Do not unscrew the sealant bottle from
the receiver until it is empty, as
sealant will leak out.
If the tyre inflation pressure does not
reach 1.8 bar (26 lb/in²) within seven
minutes, the tyre may have suffered
© 2011-2025 Copyright www.rrevoque.org
