Range Rover Evoque: Dual view selection

When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view.

To select dual view, press the dual view hard key on the fascia surround. See 111, AUDIO/VIDEO CONTROLS.

Press again to display the dual view Options menu. From here, a change can be made to the viewing source or dual view can be cancelled.

If TV or a video format source were being viewed previously, the same source will be displayed.

READ NEXT:

 Dual view control menu

Dual view control menu 1. Select to cancel dual view and revert to the menu for the current video source (TV, DVD). Note: The preview screen will be deactivated if the vehicle is moving. 2. Se

 Dual view tv operation

If you would like to change the TV programme while the vehicle is moving, there are two methods available; 1. Press the dual view hardkey to display the control menu. Select an alternative channe

 Dual view video operation

When the video programme begins play, a root menu with information about the video programme and its content will be displayed on screen. Note: Information and style may vary due to differing vid

SEE MORE:

 Rear Lower Arm FWD

Removal NOTES: LH illustration shown, RH is similar. Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Wheel and Tire (204-04 Wheels and Tires, R

 Starting a disabled vehicle using a starting aid

To start the vehicle using a starting aid or a slave battery, follow the instructions in the sequence given. 1. Connect the positive (Red) booster cable to the positive (+) battery terminal of the discharged battery. 2. Connect the negative (Black) booster cable to the vehicle earth point. 3

© 2011-2025 Copyright www.rrevoque.org