Range Rover Evoque manuals

Range Rover Evoque: Fuel filler flap

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Fuel and refuelling / Fuel filler flap

and Take note of all warnings and instructions given on the label affixed to the inside of the filler flap.

The fuel filler flap is located on the right-hand side of the vehicle, at the rear.

1. If a locking fuel filler flap is fitted, ensure that the vehicle alarm system is disarmed.

Note: The fuel filler flap can be opened only when the vehicle alarm is disarmed.

2. Press the flap to unlatch it. Open the flap until the hinge lock fully engages.

After refuelling, tighten the cap until it clicks three times.

3. To close the filler flap, push the flap until latched closed.

Note: The filler flap will only be locked closed when the vehicle is centrally locked.

READ NEXT:

 Fuel filler

When refuelling ensure that all windows, doors, and sunroof are fully closed, particularly if young children or animals are in the vehicle. Do not attempt to fill the tank to its maximum capac

 Diesel misfuelling protection device

When the misfuelling device is activated, it may cause fuel to be discharged from the filler neck. Note: It is the driver’s responsibility to fill the vehicle with the correct fuel. The diesel

 Fuel tank capacity

Avoid the risk of running out of fuel and never intentionally drive the vehicle when the fuel gauge indicates that the tank is empty. When refuelling your vehicle after the fuel gauge reads empty,

SEE MORE:

 Fender Apron Lower Panel

Removal NOTES: The fender apron lower panel is manufactured from mild steel. The panel is serviced less its weld studs This method describes the LH fender apron lower panel, the RH side is similar. 1. The fender apron lower panel is replaced in conjunction with: Front bumper cover Front bumper

 Liftgate Alignment, Front Door

Liftgate Alignment NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. With the liftgate closed, check the alignment of the liftgate to the roof panel and bodyside panel. The liftgate should be central in its aperture. 2. Refer to: Rear Spoiler

© 2011-2025 Copyright www.rrevoque.org