Range Rover Evoque: Navigation System

Navigation System

Principles of Operation

NOTE: This navigation system is installed in selected Asia market vehicles only.

For a detailed description of the navigation system, refer to the relevant Description and Operation section of the workshop manual. REFER to: (415-01 Information and Entertainment System)

Inspection and Verification

CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.

NOTE: Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.

1. Verify the customer concern

2. Visually inspect for obvious signs of damage, water ingress and system integrity

Visual Inspection

Range Rover Evoque. Navigation System

3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step

4. If the cause is not visually evident, verify the symptom and refer to the Symptom Chart

Symptom Chart

Range Rover Evoque. Navigation System

Range Rover Evoque. Navigation System

Pinpoint Tests

NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval Program is in operation, prior to the installation of a new module/component.

Range Rover Evoque. Navigation System

Navigation Control Module Locations

Range Rover Evoque. Navigation System

Range Rover Evoque. Navigation System

DTC Index

For a list of diagnostic trouble codes that could be logged on this vehicle, please refer to Section 100-00.

REFER to: Diagnostic Trouble Code (DTC) Index - DTC: Navigation Control Module (NCM) (100-00, Description and Operation) / Diagnostic Trouble Code (DTC) Index - DTC: Touch Screen (TS) (100-00 General Information, Description and Operation).

READ NEXT:

 Multifunction Electronic Modules

Torque Specifications Front Door Module (FDM) Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01

SEE MORE:

 Front Side Member

Removal NOTES: The front side member is manufactured from RP260 and DP600. The front side member long section is cut from the front side member and is manufactured from RP260. The service panel is serviced not fully spot welded. 1. In this procedure, to make sure the vehicle is correctly aligned,

 Warning Devices

Warning Devices - Component Location Component Location - Blind Spot Monitoring System Battery Voltage quality module CJB (central junction box) RH (right-hand) door mirror RH blind spot monitoring module RJB (rear junction box) LH (left-hand) blind spot monitoring module LH door mirror B

© 2011-2025 Copyright www.rrevoque.org