Range Rover Evoque: Tpm system messages
When a problem is detected, the warning lamp will illuminate or flash. A text message will be displayed. Until the fault is rectified, the warnings will be repeated each time the ignition is switched on.
Driving through variable climatic conditions can affect tyre pressures. This in turn may promote intermittent TPM system warnings.
If all four road wheels and tyres are replaced with non TPM system wheels, e.g., a set of winter wheels and tyres, the message TYRE PRESSURE MONITORING UNAVAILABLE will be displayed. When the original wheels are refitted, the vehicle will need to travel a short distance before the TPM system recognises the wheel sensors. At that point, TYRE PRESSURE MONITORING AVAILABLE will be displayed.
The system will automatically recognise any changes in wheel positions. The vehicle must be stationary for 15 minutes during a wheel change to allow the system to detect the change. See 208, CHANGING A ROAD WHEEL.
After driving above 25km/h (18mph), any deflation warning should clear within a few minutes.
If a non TMP system temporary spare wheel is fitted, the system will automatically recognise the change in wheel positions. After approximately 10 minutes of driving above 25km/h (18mph), the message FRONT (REAR) RIGHT(LEFT) TYRE PRESSURE NOT MONITORED will be displayed, accompanied by illumination of the warning lamp.
The warning lamp will first flash and then illuminate continuously. Extended use of the temporary spare wheel will trigger the message TYRE PRESSURE MONITORING SYSTEM FAULT.
This TPM system display sequence will be activated at every ignition cycle, until the temporary spare wheel is replaced by a full size TPM system road wheel.
Note: If in use, always replace the temporary spare wheel before having a TPM system fault investigated.
If any message fails to clear after rectifying the fault, consult your Dealer/ Authorised Repairer.
READ NEXT:
Tyre change
Valve stem seal, washer, nut,
valve core
and cap should be replaced at every tyre
change. Valve stem seal, washer and
nut must be replaced if valve retention
nut is loosened. Sensor units and n
Replacement sensor
Should the sensor require replacing, it should
be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a
running wheel in order to be recognised by the
system. The v
SEE MORE:
Sitting in the correct position
The driver
and front seat passenger
must not ride with the seat fully
reclined.
Do not adjust
the seat while the
vehicle is moving.
The seat, head restraint, seat belt and airbags,
all contribute to the protection of the user.
Correct use of these components will give you
greater prote
Intake Air Distribution and Filtering - GTDi 2.0L Petrol
Intake Air
Distribution and Filtering - Component Location
COMPONENT LOCATION
Purge hose from charcoal canister
Clean air purge hose
Clean air inlet ducts
Camshaft cover vent pipe connection
Sound generator duct
Sound generator
Air cleaner housing
Dirty air intake duct
Sound generator hos
