Range Rover Evoque: Trailer electrical connection
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Towing / Trailer electrical connection
Connect only approved
electrical
circuits, which are in good condition, to
the trailer socket.
The vehicle connector provides a 5 amp output which must not be exceeded. An accessory harness kit increasing output to 15 amp is available from your Land Rover Dealer.
When a trailer electrical connection is made and the vehicle’s direction indicators are used, the trailer warning indicator will flash in time with the direction indicators.
READ NEXT:
Powered tailgate
When towing, ensure there is
sufficient
clearance before opening or closing the
tailgate.
Parking aids
The rear parking aids sensors are automatically
disabled when a trailer with an approved
electrical connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking
Trailer stability assist (TSA)
When a trailer is attached, TSA will
automatically detect when a trailer sway is
developing. It will then gradually reduce vehicle
speed by cutting engine power and applying
the brakes to help reg
SEE MORE:
Anti-Lock Control
Torque Specifications
Anti-Lock Brake System (ABS) Module
Removal
CAUTIONS:
If brake fluid is spilt on the paintwork, the affected area must be
immediately washed down with cold water.
Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contai
Transfer Case Seal
RH GTDi 2.0L Petrol
Special Tool(s)
100-012
Slide Hammer
205-872
Installer, Transfer Case Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
alway
© 2011-2025 Copyright www.rrevoque.org
