Range Rover Evoque: Keyless entry
Keyless entry allows the vehicle to be opened if a Smart Key is within 1.0m (3ft) of the door handle or the tailgate external switch.
The Smart Key may not be detected if it
is placed within a metal container or if it
is shielded by a device with a back-lit
LCD screen, such as a smart phone,
laptop (including laptop bag), games
console etc. Keep the Smart Key clear of
such devices when attempting Keyless
entry or Keyless starting.
Note: The Smart Key needs only to be on the driver’s person or in a non-metallic bag or briefcase. It does not need to be exposed or handled.
When keyless entry operates, the alarm will be disarmed and the doors unlocked according to the current unlock/entry setting (Single or Multi-Point). The hazard warning lamps will flash twice as ‘unlock’ confirmation. Power folded mirrors will fold out (if enabled).
Note: If Single Point Entry is the current security setting and a door other than the driver’s door is opened first, all doors will unlock.
READ NEXT:
Smart key check
If the ignition is on or the engine is running and
there is no Smart Key inside the vehicle when
the last door is closed, the message Smart Key
Not Found Refer to Handbook will be displayed
in the
Disarming if the smart key and keyless entry fail to work
The vehicle can still be unlocked and the alarm
disabled. To unlock the vehicle:
1. Unlock the left side front door using the
key blade. The alarm will be triggered.
2. Position the Smart Key agai
Deactivating the alarm when triggered
If the alarm has been triggered, it can be
deactivated by any one of the following
methods:
- Pressing the unlock button on the Smart
Key.
- Opening a door using keyless entry.
- Positioning a v
SEE MORE:
Transfer Case Fluid
Level Check
CAUTION: The fluid filler plug is not a fluid level plug.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Fron
Inner Back Panel Assembly
Removal
NOTES:
The inner back panel assembly is manufactured from mild steel.
The panel is serviced less its weld studs.
The new service panel is not fully spot welded when supplied.
It is necessary to remove a section of one rear lamp mounting panel to enable
removal and installation of the inn
